Fact table size cannot be zero

Last Post 20 Oct 2005 12:00 PM by WCBJBrown. 0 Replies.
AddThis - Bookmarking and Sharing Button
Author Messages
WCBJBrown
New Member
New Member

--
20 Oct 2005 12:00 PM
I build a cube with a fact table and 3 dimensions and it processes properly. I get the results I want and it looks good. When I go back in and try to edit the cube I have no problems but when I open the data tab or try to reprocess the cube I get the message 'Fact table size cannot be zero'. Has anyone seen this before? Any suggestions?

Thanks,

Jim Brown

P.S. If I delete the cube and recreate it everything is OK agian. Until I try to edit it again.


Acceptable Use Policy
---